Problems compiling ecn28J60 register names

[DaveC3]

I am working on a program to run a enc28J60. I am using a 18F4550 and PBP 2.60b. If I declair constants using the 28J60 register names I get Syntax errors. If I prefix the register name it compiles,

as example, This works

enECON2 con  $1E
enECON1 con  $1F
'---- Bank 0 registers
eERDPTL           con    $00|$00
eERDPTH           con    $01|$00
eEWRPTL           con    $02|$00
eEWRPTH           con    $03| $00

This does not work using the real register names

ECON2 con  $1E
ECON1 con  $1F
'---- Bank 0 registers
ERDPTL           con    $00|$00
ERDPTH           con    $01|$00
EWRPTL           con    $02|$00
EWRPTH           con    $03| $00

These are not on the reserved word list for PBP.

Any ideas?

Thanks

Dave

[Darrel Taylor]

Make sure you are compiling for an 18F4550.

The PIC's with ethernet controllers have the same type of controller built-in to them.
So the register names are already defined in the PIC18ETH.BAS file.

But that file is only used with the ethernet enabled PIC's.

[Darrel Taylor]

Hmmm, I was compiling with 2.60A

With 2.60B there is a problem.
I'm searching .......

[Darrel Taylor]

Whoops ...

Those register names got added to the PIC18EXT.BAS file. (they shouldn't have)

If you comment the corresponding lines in that file, your program should compile.

This will be fixed ASAP.

[DaveC3]

Thanks Darrel

That worked. Will there be a update to correct this?

Dave

[Darrel Taylor]

Charles has fixed the problem and the next patch will have the corrected files.