Low frequency audio level detector using PIC ADC?

Results 1 to 40 of 69

Threaded View

  1. - 21st February 2011, 19:14 #29
    cncmachineguy's Avatar
    cncmachineguy
    cncmachineguy is offline Senior Member
    Join Date
    Aug 2010
    Location
    Maryland, USA
    Posts
    869

    Did you find this post helpful? Yes | No

    Default Re: Low frequency audio RMS signal level detector using PIC ADC?

    Quote Originally Posted by HankMcSpank View Post
    Ok, yes, I'm getting there (thanks), but I come back to how did you know the main took 7 instructions, once again, here's the main...

    Code:
    BMAIN:  'make this your new temporary main for this test
 toggle portc.4   'pin 6   (green scope trace)
GOTO BMAIN
    So, to my eyes, there are two instructiions there ...the toggle & the goto ...do these add upto to the 7?
    The confusion comes from my exclusion. When I am talking about number of instructions, I mean to say ASM instructions. This just shows the beauty of PBP. I prolly should use the term fosc/4, but I have always just thought about it as instructions. BTW, some take 1(fosc/4) and some take 2. GOTO (in ASM) takes 2 while BCF (clears a bit) takes 1
    Last edited by cncmachineguy; - 21st February 2011 at 19:16.
    -Bert

    The glass is not half full or half empty, Its twice as big as needed for the job!

    http://foamcasualty.com/ - Warbird R/C scratch building with foam!
« Previous Thread | Next Thread »

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules