I am using Melabs bootloader for the first time. I have been able to load and run my blinkLED programs fine. While reading post on loaders I have come across several items discussing configs can not be loaded with your program but must be loaded at Bootloader installation. Well at least that’s what is sounds like. I am not sure how to set the configs during the installation of the loader Hex file. Is this done using the Melabs programmer? If I click the “C” button and set configs will that program the PIC when I install the Bootloader? Once I Read after programing I am not sure if the PIC is now set with those config settings? Also, I am not sure if the Program hex file that contains “Data” instructions to load the on board EEprom are actually loading the EEprom? I am not sure how configs and on board EEprom should be handled using the Bloader. Comments please.