I've been around long enough to know a dumb question when I see it, and I'm pretty sure this is one.... but here goes.
I've got a some hardware connected to a PIC board that can generate an interrupt (DT_INT0) if different hardware alarm conditions exist. When the board is first powered up, however, no alarm conditions are reported until the first (real) interrupt happens, because nothing has actually generated an interrupt since power up. So... I need to programmatically generate an INT0 on power-up to report any alarm conditions that already exist.
How do you do that? I tried a GOSUB to the INT0 handler, and it didn't error, but also didn't work.
Bookmarks