"symbol not previously defined" on 16F1933 - fuse issue i think

[comwarrior]

ok, i write 3 lines of code and already i get an error...

ERROR[113] blah.asm 328: Symbol not previously defined (_CONFIG1)
ERROR[126] blah.asm 328: Argument out of range (not valid config register address)
ERROR[113] blah.asm 334: Symbol not previously defined (_CONFIG2)
ERROR[126] blah.asm 334: Argument out of range (not valid config register address)

and my code...

Define  OSC				32					' Set clock speed
@ __config __CONFIG1, _FOSC_INTOSC & _WDTE_NSLEEP & _PWRTE_ON & _MCLRE_OFF & _BOREN_ON & _IESO_OFF & _FCMEN_ON
@ __config __CONFIG2, _VCAPEN_OFF & _PLLEN_ON & _STVREN_ON & _BORV_25 & _LVP_OFF

In P16F1933.INC in the MPASM SUITE folder it says...

;==========================================================================
;
;       Configuration Bits
;
;   NAME            Address
;   CONFIG1           8007h
;   CONFIG2           8008h
;
;==========================================================================

; The following is an assignment of address values for all of the
; configuration registers for the purpose of table reads
_CONFIG1         EQU  H'8007'
_CONFIG2         EQU  H'8008'

ok, i have no idea...
Can someone shed some light please. Thanks

:additional
I checked the datasheet, the config word addresses are correct...