Making a timer, 32.768kHz+555+DT_INT. Good idea?

[financecatalyst]

I made my circuit on my breadboard. It works kind of OK (INT are longer than 1 sec intervals) with TICON=%00001111 the clock still keeps incrementing even when I take out the 32KHz crystal from RC0-RC1.

The clock stops with
TICON=%00001011, seems Interrupts stop happening with this setting. Can someone please put some light on why this could be happening?

[financecatalyst]

Anyone? Should I start a new thread with this problem?

[mackrackit]

Maybe??
Do you have the Watchdog turned off?

[financecatalyst]

Maybe??
Do you have the Watchdog turned off?

Observations:
Watchdog is OFF.I just tried it with 4MHz oscillator, everything works fine. Intervals are 1 sec as expected. I took out the 32kHz crystal while PIC was working, it suddenly increased the speed of counting seconds(I WAS EXPECTING IT TO STOP ENTERING IN ISR) i.e. interrupts started happening a little faster. I inserted the crystal back in, the speed became ideal i.e. 1 sec interrupts.
Two questions now please:
1) Why didn't the Interrupts Stopped when I took the crystal out?
2) Why things get slow when I use 32768 Hz crystal as an oscillator for the PIC as well as the timer? 4MHz for PIC increases the current consumption to 2.5mA which is criminal when running on batteries.

[Darrel Taylor]

Are you saying that you have two 32768 crystals?
The CPU will be running at 8192 hz (FOSC/4).

You might as well run the timer off the main clock then, (saves the power used by the timer1 oscillator), and gives the same accuracy.
T1CON = 1
Reload TMR1H with $11100000, and definitely put it First in the handler.

And change the LCD timing because PBP still thinks it's running at 4mhz.

DEFINE LCD_COMMANDUS 17
DEFINE LCD_DATAUS 1

[financecatalyst]

Are you saying that you have two 32768 crystals?
The CPU will be running at 8192 hz (FOSC/4).

You might as well run the timer off the main clock then, (saves the power used by the timer1 oscillator), and gives the same accuracy.
T1CON = 1
Reload TMR1H with $11100000, and definitely put it First in the handler.

And change the LCD timing because PBP still thinks it's running at 4mhz.

DEFINE LCD_COMMANDUS 17
DEFINE LCD_DATAUS 1

With recommended settings above i.e. TMR1H with %11100000 can someone please help me understand how many seconds or minutes the clock will be out after a month or an year because it gives me 1.00069 Hz frequency for Timer1

[Darrel Taylor]

That would gain about 2.5 seconds per hour, which is not good.

Have you set LP oscillator mode in your configs?
Since it worked for you at 4mhz, it's probably set to XT and over driving the crystal.

How are you measuring that frequency?
Is it a high quality frequency counter?
Accurate measurements of low frequencies can be difficult, with large errors.