What is this error : Address Limit of FFFh Exceeded

**lerameur** · - 25th November 2010, 04:37

Hi well i will post the full 500 line program tomorrow.
As for the programmer I use the Olimex programmer with usb connection. works great with the 16F series says it works with the 18F too but never tried it. just wandering if the programming if the ports is much di8fferent..
ken

**mackrackit** · - 25th November 2010, 09:21

Working with the 18Fs is not really any different than the 16Fs.

The 18Fs have many more options so sometimes the configs are a little more difficult, but the default setup in the PBP *.inc file is good to get started.

The benefits make running the 18Fs worth it in many cases.

**lerameur** · - 25th November 2010, 12:39

I think I will go aheah and get started with the 18F series. I will see what happens then programming it.

K

**lerameur** · - 25th November 2010, 12:45

I was looking through the *.inc files..

I dont see it for the 18F2445 also i looked atthe chip I know most 16F88 and could not find it either ! I am not familiar with the INC files. What are they used for ?.

K

**mackrackit** · - 25th November 2010, 14:34

I dont see it for the 18F2445

I do not find it on Microchips web site either. Do you mean another chip? 2455?
The 2455 is in PBPs current version, I do not remember when it was added.

The 16F88 is there. If Micro Code has it then it is in the PBP directory.

I am not familiar with the INC files. What are they used for ?.

That is where the configuration bits are set.

One other thing about the 18Fs. You hace to use MPASM for the assembler. PM will not work.