Close...

Here is a copy of the chip setup...
What have i missed?

Code:
@ __CONFIG _CONFIG1L, _PLLDIV_5_1L & _CPUDIV_OSC1_PLL2_1L & _USBDIV_1_1L
@ __CONFIG _CONFIG1H, _FOSC_INTOSCIO_EC_1H & _FCMEN_ON_1H & _IESO_OFF_1H
@ __CONFIG _CONFIG2L, _PWRT_ON_2L & _BOR_ON_2L & _BORV_2_2L & _VREGEN_OFF_2L
@ __CONFIG _CONFIG2H, _WDT_ON_2H & _WDTPS_32768_2H
@ __CONFIG _CONFIG3H, _MCLRE_OFF_3H & _PBADEN_OFF_3H
@ __CONFIG _CONFIG4L, _STVREN_ON_4L & _LVP_ON_4L &  _ICPRT_OFF_4L & _XINST_ON_4L & _DEBUG_OFF_4L

Define  OSC				8						' Set clock speed

' Setup chip                                    
INTCON.7 = 0                                    ' Disable interupts
INTCON.6 = 0
INTCON.5 = 0
INTCON.4 = 0
INTCON.3 = 0
PIE1 = 0                                         ' Disable interupts

T0CON.7 = 0                                     ' Disable TMR0
T1CON.0 = 0                                     ' Disable TMR1
T2CON.2 = 0                                     ' Disable TMR2
T3CON.0 = 0                                     ' Disable TMR3

ADCON0.0 = 1                                    ' Enable ADC module
ADCON1.5 = 0
ADCON1.4 = 0
ADCON1.3 = 1                                    ' Set ADC ports
ADCON1.2 = 0                                    ' Set ADC ports
ADCON1.1 = 1                                    ' Set ADC ports
ADCON1.0 = 0                                    ' Set ADC ports
TRISE = %11000000								' Set PortE to all outputs
TRISD = %00000000								' Set PortD to all outputs
TRISC = %00000000								' Set PortC to all outputs
TRISB = %00000000								' Set PortB to all outputs
'TRISA = %00000000	 							' Set PORTA to all OUTPUTS

' initialise IO
PORTA = %00000000                                ' Make Port low
PORTB = %00000000                                ' Make Port low
PORTC = %00000000                                ' Make Port low
PORTD = %00000000                                ' Make Port low
'PORTE = %00000000                                ' Make Port low