I am beginning to think there may be something wrong my machine. The other day, writing parameters to a 485 buss DPM and I think it corrupted the calibration memory of a couple temperature panel meters. That area of memory was not supposed to be accessable to the user. Just after writing to it the scaling and zero went all off.

With MSC+ I thought I did as advised on the install but am not sure anymore. The battery is dead and charger at work so will need to try remove and reinstall tomorrow to see if it helps. Is there anything special that I should do to remove??

The randomness of the program failures on startup are strange. I get appcrash in the details of the fault and it is in areas of different modules not the same faults every time. Only consistant is that it seems to do it right on startup of the program.

So whats up with microsoft anyway. I wonder why they left out support for HID devices in the legacy devices for XP VM. I saw some other users with the same complaint with foot pedals and other hardware that is unavailable in that mode as well. Makes it kind of useless if you can't see hardware.