pic18f887 event timer

[cpayne]

...perhaps the errors mean something to those who know, but I am not smart enough to know (hence the reason I am for asking for help). A little more guidance would be appreciated. am I suposed to edit pbppic14.lib, if so how and where, its a huge file. Or am I suposed to change the includes file for the PIC16F887?

Thanks,
Charlie

[Darrel Taylor]

Add ...

wsave VAR BYTE $70 SYSTEM

to your program.

[cpayne]

OK. Thanks, Compiles now and have a blinking LED. Back to the timing... Sorry I am so dense with this.

How do I go about setting the timer for prescale of 1 and a peload of 21537

I have been looking at previous posts and the datasheet for the 16f887, but not really sure what I need to do.

I assume I have to set T1CON and perhaps OPTION_REG

Also would I be better off using Timer2 since its 8bit (would it be less resources, etc?). As the timer is tripping along, there is no issue with timing of other things like serial commands, I2C timing, etc?

[mackrackit]

http://www.picbasic.co.uk/forum/show...7472#post17472
Has the example to set the pre-scaler.
Then in your code for the pre-load.

PreLoad     VAR WORD
PreLoad =  21537 
TMR1L = PreLoad.LowByte
TMR1H = PreLoad.HighByte

Then in the interrupt routine

TMR1L = PreLoad.LowByte   ' Load the timer with preload value.
TMR1H = PreLoad.HighByte

Maybe....

[cpayne]

cool. I had it in the begining, did not have it in the interupt. Firing every 22ms on the scope.

So, this will not mess up anything as far as I2C or serial? or is that dependent on what I do during the interupt? (The final interupt will take about 10-14ms and fire off every 22ms)

[mackrackit]

So, this will not mess up anything as far as I2C or serial? or is that dependent on what I do during the interupt? (The final interupt will take about 10-14ms and fire off every 22ms)

You need to get in and out of an interrupt routine as quick as possible.
So if the I2C and serial stuff is handled out side then you should be good.

[cpayne]

In order to get in and out quick I will need to use another timer I guess. I need to fire off serries of 8 pulses every 22ms. The high pulses will range from 400us to 1800us with a 400uslow pulse/pause between each one. So I am looking for some advise as to the best approach. Would be the best approach it with a second timer or the same one? I guess if I use the same one I can add up all the small pulses and then wait the difference of 22ms and repeat, but I am not sure if that is as reliable as using two timers, perhaps simpler though. If two timers, should I use timer1 (the 16 bit one for the shorter pulses since their accuracty is more critical than the 22ms) and timer0 or timer2 for the 22ms event. Is there any big deal with changing the preload value for the shorter pulses each time?

In either approach, can I use a case select inside the interupt routine to remember where I am in the interupt pulse train each time I return, or is there something I have to do to pass variables in and out of the interupt routine.

Thanks,
Charlie