hello all,

i'm very happy that i found you site. I'm very new to PbP programming. Actually i have very basic knowledge and would like ta have some help if you have time.

So lets start from what i have in mind to do.

1)I would like to use at first the PIC12f629.

2)I need to use one button.

3)and one LED

Now.... i want to press the button and light the LED on 10 % of brightness

then to press it again and light it to 50 % and then press again and light it to 100%

At the end if i press it once more to turn off the LED.

Actually if it is simple enouph i would like to turn the led off if i press the button more that 3 seconds.

If this is very difficult to do please do not be bother to help me i dont want to disturb you. But if anyone have time i would be very please.

What i have done till now is not a lot.

I have turned on an LED and turned off.

Then i can use PWM GPIO.0,a + 1,2 to light the LED but none more.

I have also an other problem that i cannot turn on with PWM command more that one GPIO.

For example i would like to turn on the LED from 0 to 255 and then from 255 to 0 but on the port GPIO.0, GPIO.1 and GPIO.2, how can i do that?

Thank you very much for your help in advance.

Best Regards

astanapane.