Initial LAB-X1 Setup

Results 1 to 3 of 3

Threaded View

  1. - 10th October 2010, 05:54 #2
    ScaleRobotics's Avatar
    ScaleRobotics
    ScaleRobotics is offline Prolific Poster
    Join Date
    Feb 2006
    Location
    Gilroy, CA
    Posts
    1,530

    Did you find this post helpful? Yes | No

    Default

    There is a jumper JP1 that lets you decide if you are going to power the LAB-X1 with the programmer, or with external power. If the chip is not getting power, then it will not be recognized. If running LAB-X1 power from a transformer, then leave the jumper off, but if you are going to power it with the programmer, put it on. It should recognize the chip. You are right, just straight with your ribbon cable.

    You might have seen this already:
    http://melabs.com/support/connections.htm
    Last edited by ScaleRobotics; - 10th October 2010 at 05:59.
    http://www.scalerobotics.com
« Previous Thread | Next Thread »

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules