The forum is a canned system from V Bullitin so we can not do anything tied directly to it.
But Lester has made free websites available to forum users so maybe we could play with something there.
I will do some poking around. Could be fun.
|
The forum is a canned system from V Bullitin so we can not do anything tied directly to it.
But Lester has made free websites available to forum users so maybe we could play with something there.
I will do some poking around. Could be fun.
Dave
Always wear safety glasses while programming.
|
well Dave,
as it appears I have you at least intrested, do you have any ideas on how to use the wizard? I mean as a plugin, stand alone ....
-Bert
The glass is not half full or half empty, Its twice as big as needed for the job!
http://foamcasualty.com/ - Warbird R/C scratch building with foam!
|
I was thinking something along the lines of SQL with a web interface (python of course).
To add data a form page would be used, so we will need to figure out what all this thing should do so a standard form can be used. Might have to have a couple standard forms, 16Fs and 18Fs.
Then a form for to set the parameters for the header.
Just a bit of planning to do.
Anyone else with ideas?
Dave
Always wear safety glasses while programming.
|
Maybe fuse configuration would be a good place to start?
Dave
Always wear safety glasses while programming.
|
And after we set up all the necessary little things on the form, Microchip(c) wll make this tiny change and screws everything
OK, I am joking, but the Form/SQL may have to be prepared for such a case.
Fuse settings is a good starting point as there is a lot of confussion on this. Every time I change a chip I have to scan the fuse settings which arfe not very obvious sometimes.
Ioannis
|
Go from depreciated to inflated...Originally Posted by Ioannis
And after we set up all the necessary little things on the form, Microchip(c) wll make this tiny change and screws everything
OK, I am joking, but the Form/SQL may have to be prepared for such a case.
We may have to make a script for that.
You too? My last big problem was a fuse mistake.Fuse settings is a good starting point as there is a lot of confussion on this. Every time I change a chip I have to scan the fuse settings which arfe not very obvious sometimes.
Give me a day or two and I will try to get something started.
Dave
Always wear safety glasses while programming.
|
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks