Embedded strings in code mpasm error

[malc-c]

Not that I have the answer, but if you could inform us what the target PIC is it might helpw those with more knowledge than I to advise.

My guess is that you need to edit the associated .INC file for the chip you are using by commenting out the config lines. This file is located in the PBP folder.

EG:

;****************************************************************
;*  18F4580.INC                                                 *
;*                                                              *
;*  By        : Leonard Zerman, Jeff Schmoyer                   *
;*  Notice    : Copyright (c) 2008 microEngineering Labs, Inc.  *
;*              All Rights Reserved                             *
;*  Date      : 09/15/08                                        *
;*  Version   : 2.60                                            *
;*  Notes     :                                                 *
;****************************************************************
        NOLIST
    ifdef PM_USED
        LIST
        "Error: PM does not support this device.  Use MPASM."
        NOLIST
    else
        LIST
        LIST p = 18F4580, r = dec, w = -311, w = -230, f = inhx32
        INCLUDE "P18F4580.INC"	; MPASM  Header
        ;__CONFIG    _CONFIG1H, _OSC_HS_1H & _FCMEN_OFF_1H & _IESO_OFF_1H
        ;__CONFIG    _CONFIG2H, _WDT_ON_2H & _WDTPS_512_2H
        ;__CONFIG    _CONFIG3H, _PBADEN_OFF_3H & _LPT1OSC_OFF_3H & _MCLRE_ON_3H
        ;__CONFIG    _CONFIG4L,  _STVREN_ON_4L & _LVP_OFF_4L & _BBSIZ_1024_4L & _XINST_OFF_4L
        NOLIST
    endif
        LIST
EEPROM_START	EQU	0F00000h
BLOCK_SIZE	EQU	8

Also... if using microcode studio to edit... make sure you have the correct target chip selected