Transmission!

[mackrackit]

according to me i just have to serially send data to the radio and then it will transmit it. No more extra connections required. i just wanna know the particular commands for sending serial data (i.e through tx and rx pins of port c).

serout2
hserout

[Ioannis]

How are you going to use the devices?

Do you have your own board or using the DIGI's dev kit?

The XBees require TTL Serial connection, not inversed by a driver when connecting to a microcontroller.

I suggest use the dev. kit to test them and set parameters, then connect to a micro.

Ioannis

[uaf5000]

Thanks Mack for the commands. But can u tell me precisely how to use them? Should there be some defines before i use these serial out commands? I have given the code, can you manipulate it accordingly?


I have Xbee XBIB board for one radio while ill plug the other radio in my own board where the microcontroller is placed (off course). I can set the parameters of my radio through this board and device software given by DIGI.

[mackrackit]

Thanks Mack for the commands. But can u tell me precisely how to use them? Should there be some defines before i use these serial out commands? I have given the code, can you manipulate it accordingly?

Hmmmm
I do not normally say this but.... RTFM
Then let us know the parts you do not understand.

HSERIN does have defines.