A question regarding PIC16F684 to LCD.

[Peter.]

...be sure to read the section of the data sheet I pointed to to see why the analog settings did not cause the problem...

Thanks for that.
Okay by you if I pick your brains one more time, pse?.....
Just for the sheer sake of learning/curiosity, I'm reading the value of a standard 1mS~2mS R/C pulse, then writing that value to the LCD (Input mode). One of the ADCs is used to create another 1mS~2mS pulse, then displaying that value and at the same time sending the pulse to a separate pin (Output mode)... which works fine on ports A.1 and A.2, but not on ports A.3 ~ A.5.
I'm not sure that I'm fully understanding the ANSEL/TRISA thing because neither does the mode selection work when A.2 is HIGH - the program jumps straight to output mode and stays there.

Thanks again for your previous help. Appreciate you coming back.