I recently purchased MCSP v4.0.0.0 from Melabs. When I installed it, the assembler default was set to MPASM. I had previously tried the free MCS download version and this wasn't an issue.

On trying to compile I had similar error messages about not finding .inc files etc. When I unchecked MPASM all was well. I am using PBPro V2.60.

Hope this helps

David


Quote Originally Posted by Joe S. View Post
Hi tevriz,
I would question your installation of PBP. Did you install from a MeLabs install disk, or some other fashion ? If you do not have an Authorized disk I suggest you go to MeLabs website and download the PBP Demo. It will allow you to write simple programs up to 31 lines of code. If you Have an authorized disk then I would reinstall PBP from it and select all the default directories, because MCS is complaining about not being able to find files that should be there.