MicroSD Cards and SDFS

[Normnet]

Hi,

I finally got the parts that I needed and started playing with SDFS. Since I'm running my 18F4550 at 3.3V I connected all the MicroSD card pins directly to the PIC. I did not install the 10k resistors since my configuration is a little bit different. Do I need to use these 10K resistors?
Robert

I haven't seen the wiring diagram but a 10k resistor would only be required for a 5 volt PIC to
pull up the PIC in-data line as well as others to split the PIC 5 volt lines to SD 3.3 volts.

Norm