Bruce,
What kind of breadboard will they fit into?
If JP6 is 0.1" spacing, then JP5 and JP7 are 1.5" apart.
But all my solderless breadboards are 1.1" max.
The headers would end up in one of the power rails.
|
Bruce,
What kind of breadboard will they fit into?
If JP6 is 0.1" spacing, then JP5 and JP7 are 1.5" apart.
But all my solderless breadboards are 1.1" max.
The headers would end up in one of the power rails.
DT
|
Duh! Nevermind.
It would go across the power rails between two breadboard strips.
Sorry, I'm just excited about it.
Carry On.
DT
|
Hi Darrel,
I suppose it could be done, but the board would be pretty long, and there wouldn't be any room for labels on the connection headers. The 64-pin PIC32 TQFP package is pin-to-pin/side-to-side 12mm wide, so you have little to no room.
|
No problem.
I'm sure it will work just like this ...
In fact, it fit so well I figure you must have designed it that way.
Works for me.
DT
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks