Help in sending hex string using serout

[Ioannis]

The command that you posted, is not correct. Use modedefs.bas with the Serout and at mode the nams like T2400 or N9600 etc. Look at the manual for he correct syntax.

Now about the numbers, since they are inside "" they are treated as a long string message.

Ioannis

[mbox]

Hello Ioannis,
Thanks for the reply....

The command that you posted, is not correct. Use modedefs.bas with the Serout and at mode the nams like T2400 or N9600 etc. Look at the manual for he correct syntax.

Now about the numbers, since they are inside "" they are treated as a long string message.

Ioannis

Here is the whole code

 Include "modedefs.bas"
CLEAR	
 TRISC = %10000000'set TX (PORTC.6) to out, rest in
 TRISB = %00000000
 PortB = %00000000
 pause 20
 SerOut PortC.6,T9600, ["0x02 0x52 0x04 0x0b 00 0x61 0x0A 0x4D 0x6f 0x62 0x6f 0x74 0x20 0x49 0x49 0x49 00 0x03"]
 pause 10    
 SerOut PortC.6,T9600,["0x02 0x52 0x66 00 00 0xb8 0x03"]
 pause 10
 Serout PortC.6,T9600, ["0x02 0x52 0x04 0x0b 00 0x61 0x0A 0x4D 0x6f 0x62 0x6f 0x74 0x20 0x49 0x49 0x49 00 0x03"]

Can you help me send the hex values in the proper format?

regards,
mbox

[mackrackit]

Take a look at SEROUT2.
Then you can format it something like this
HEX 42, HEX 24, ...

[Ioannis]

And note that with Serout2 that Dave showed you, a HEX modifier can have a digit also impying the number of digits to follow.

HEX2 means 2 hex digits etc.

Ioannis

[mbox]

Thanks everyone for the responce... I finally got it...
I use this in my code to send

SerOut2 PortC.6,84, [$02,$52,$27,$06,$00,$7F,$12,$13,$23,$17,$09,$00,$03]