EasyPic 5 board and MCSP

[Acetronics2]

Hi, Alexander

at this time , I have my Easypic5 connected to MCSP in debug mode, with a 16F877A ... and it works fine.

so, it's possible.

1) I use a " true " RS232 serial cable from a serial port of the PC - no USB convertor. ( choice is only COM 1,2 & 4 ... )

I have an USB > serial on com 4 ( PSU ) and it works too, if connected to EP5 ...

2) the EP5 RS232 switches ( SW7 & SW8 ) must be selected to allow the choosen Pic to use it's own USART.

except that ... nothing special.

Alain

[Alexander]

Hi, Alexander

at this time , I have my Easypic5 connected to MCSP in debug mode, with a 16F877A ... and it works fine.

so, it's possible.

1) I use a " true " RS232 serial cable from a serial port of the PC - no USB convertor. ( choice is only COM 1,2 & 4 ... )

I have an USB > serial on com 4 ( PSU ) and it works too, if connected to EP5 ...

2) the EP5 RS232 switches ( SW7 & SW8 ) must be selected to allow the choosen Pic to use it's own USART.

except that ... nothing special.

Alain

Merci Alain
What loader are you using? Is it possible to use MC Loader?
I have 16F887 on board. Its not on the list. What can I put instead?
Regards
Alexander