Software reset

[mister_e]

not sure of it... humm... what is the purpose of this software reset?

What do you expect?

Do you set all your registers at the begining?

Sure you can set all register to the default POR before the goto reset vector ... but those registers are not all to zero... see datasheet for POR setting of each registers.

[leonel]

The ideia in doing the software reset it´s that:
I have a "security command" and when this contact is closed the circuit work´s normally, but when the contact opens I don´t want that the circuit work´s, but when the contact closes again all my registers goes like it seems we remove the power, like it was the first time we were running the program...

What I´m thinking to do is modify the value on the registers that I've modified and put them at zero or to the value that had at the beginning!

[Bruce]

If you just need to clear all RAM (variables) then use the CLEAR command.

If you want to start over from location 0 simulating a power-up condition, and clear RAM without a hardware reset, then use;

@ clrf PCLATH
@ goto 0

And place CLEAR as the first BASIC instruction.

If you have a security check routine that needs to clear RAM when a switch changes state, use the CLEAR command on entry to the routine.

Lots of options.

[leonel]

Thank´s, your solution works.
I was forgetting the clear command...
The code to do a software reset is:
clear
@ clrf PCLATH
@ goto 0

Best regards
Leonel

[Worayoot]

Thank you

@ clrf PCLATH
@ goto 0

I use with 12F work very well