Code that worked with WINDSTAR LCD doesn't work with Newhaven LCD?

[jmgelba]

Nice. I'm also using a 18F2550 - for the first time. I've started browsing through the datasheet and am currently finishing up the schematic and about to start on the layout.

This project calls for several analog in's, the LCD, the USB, 4 switch inputs, and control of a digital pot. Oh and a couple of indicator LED's.

Nothing like jumping in with both feet!

[jellis00]

So it soounds like you are still building schematic/layout and haven't started coding yet??
When you get into the coding of the USB interface you will probably run into problems. I did, and got a lot of help from Darrell Taylor and the Forum. When you get to that stage and need help, let me know and I may be able to refer you to some well hidden postings that will help you with the USB.

[jmgelba]

Correct.

I've done a little searching and found the keep alive requirements and DT's keep alive program. Other than that, and the requirement for a 0.47uF cap on the USB supply pin, I havent gotten too far in to it. I'm concentrating on hardware as the first rev pcb has to work first time. I need to send out a somewhat functioning proto next week.

[jmgelba]

Are you using your display in 4 bit or 8 bit and if its 4 bit, have you tied the unused data pins to ground?

[jellis00]

Are you using your display in 4 bit or 8 bit and if its 4 bit, have you tied the unused data pins to ground?

I am using it in 4-bit and yes the unused data pins have to be grounded.

[jmgelba]

Thanks. Incidentally, the datasheet from Digikey for the part number I'm using is incorrect. It didnt show how to connect the RGB backilighting correctly. Good job I double checked by calling New Haven tech support. The pin out was wrong - missing 2 pins and swapping the backlight A and K. Yikes Digikey!!

[jellis00]

Thanks. Incidentally, the datasheet from Digikey for the part number I'm using is incorrect. It didnt show how to connect the RGB backilighting correctly. Good job I double checked by calling New Haven tech support. The pin out was wrong - missing 2 pins and swapping the backlight A and K. Yikes Digikey!!

Which LCD model of theirs are you using?
Did Newhaven warn you about incorrect data sheets on any other LCDs of theirs that are sold at DigiKey?
JE