OK its gone from bad to worse.....

On the downside my internet is down so I only have this mobile phone, but I have now dusted off my old dual trace scope...

What it Ias shown me is I seem to have a timing error...

I have changed from a 4 to a 20mhz crystal go case It was off freq.

I can't use the scope to check timing accuracy its very old and calibrated.

I can't cut and paste my configs now!

As a rule of thumb, if I use the right settings to clock the pic at 20mhz I would be right with pll/5 to be right for usb.

CAn I get a good 9600 set that way?

How many chars can be transferred in say 10 secs?

The scope shows returning data but it looks like the phone/modem. IS at a different speed