Quote Originally Posted by financecatalyst View Post
Can you please add one example to read and one to write?
I went through the manual but it does not have an example on how to write statements for INTERNAL EEPROM.
Straight from the SAMPLES folder of your compiler ...

Code:
' I2CREAD and I2WRITE Commands
'
' Write to the first 16 locations of internal I2C EEPROM
' Read first 16 locations back and send to serial out repeatedly
' Note: for PIC12CE67x MCU's

        Include "modedefs.bas"          ' Include serial modes

Define  I2C_INTERNAL  1

ADCON1 = 7				' Set ADC pins to digital operation

SO      con     1                       ' Define serial output pin
DPIN    var     GPIO.6                 	' Data line to internal EEPROM
CPIN    var     GPIO.7                 	' Clock line to internal EEPROM
B0      var     byte
B1      var     byte
B2      var     byte

        For B0 = 0 To 15                ' Loop 16 times
                I2CWRITE DPIN,CPIN,$A0,B0,[B0]  ' Write each location's address to itself
                Pause 10                ' Delay 10ms after each write
        Next B0

mainloop: For B0 = 0 To 15 step 2       ' Loop 8 times
                I2CREAD DPIN,CPIN,$A0,B0,[B1,B2]        ' Read 2 locations in a row
                Serout SO,N2400,[#B1," ",#B2," "]       ' Print 2 locations
        Next B0

        Serout SO,N2400,[10]            ' Print linefeed

        Goto mainloop
also available @ Melabs site in the support section ...

Alain