TRIS setting for the DS1302

[Dennis]

@Steve

My code before you replied ...

setclk:
        high rst         ' Ready for transfer  RTC pin must go high
        Shiftout ds_data, ds_clk, LSBFIRST, [$bf] ' send burst mode control $bf to read all 8 RTC registers in burst mode     
        Shiftout ds_data, ds_clk, LSBFIRST, [rtcsec, rtcmin, rtchr, rtcdate, rtcmonth, rtcday, rtcyear, rtccontrol] send the data
        low rst         ' Reset RTC reset pin

As you can see I was totally off the mark with the $bf , $be setting !

Ok but I have read in a lot of posts regarding the DS1302 and BCD conversion ..does this still apply ?

Kind regards
Dennis