I saw that, very handy. It would be good to buy a few expansion headers (J3) as well if I can source them, rather than solder the actual modules onto a vero board.The TX module won't push into my breadboard either (a real shame that) as the pins lie flat against the circuit board, again a J2 header would have solved that, never mind.It also looks like it you leave the program power jumper on you should be able to power the transmitter while in a breadbord from any 2 to 5 volt source.
I'm so keen to try these modules out that I've been seriously thinking of soldering the TX module to a vero board and running a power supply to it but after a rush of blood I've decided to get the battery tomorrow and have TX stand alone using the battery and RX in the PITkit1.
Roll on tomorrow.
Dave
PS: The Badger hasn't made an appearance for three nights in a row now, we're a little worried for him....
Bookmarks