Using SERIN.BAS to test setup

Results 1 to 2 of 2

Threaded View

  1. - 16th February 2005, 04:23 #1
    TurboLS's Avatar
    TurboLS Guest

    Default Using SERIN.BAS to test setup

    OK, I have SERIN.BAS compiled, assembled, and programmed on my PIC18F4520. I looked in the MODEDEFS.BAS file and I was trying to figure out how to wire up the serial port connector to the pic chip. SERIN.BAS defines S0 and S1 as pins, but I don't see how those descriptors correspond to the pic chip pins, such as PORTA.0 . Am I missing something really simple? I currently have the RS232 connector wired in the following configuration. I have the send and receive pins connected to the TX and RX pins on the PIC chip respectively.
    Attached Images Attached Images  
« Previous Thread | Next Thread »

Similar Threads

  1. Creating RF to test circuits
    By Tobias in forum General
    Replies: 2
    Last Post: - 22nd November 2009, 21:27
  2. TMR1 external LP xtal setup check
    By comwarrior in forum mel PIC BASIC Pro
    Replies: 4
    Last Post: - 13th October 2009, 18:11
  3. pic first build test board not running
    By comwarrior in forum Schematics
    Replies: 11
    Last Post: - 29th June 2009, 16:48
  4. ADCIN setup for PIC16F688
    By PixController in forum mel PIC BASIC Pro
    Replies: 0
    Last Post: - 29th February 2008, 18:38
  5. MAX232, Bootloader, Microchipc test prints garbage
    By mslaney in forum General
    Replies: 3
    Last Post: - 26th January 2005, 13:41

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules