Blank Variable

[mackrackit]

Idea...
Not sure exactly how to do it...

Use WRITECODE to over write the DATA line.

Where is the DATA line???

[GatorGuy]

Thanks for the ideas. I found an easy way now:

This isnt the code but gives the idea.

READ 0, blah
startup:
if blah = "1" then goto 1
if blah = "2" then goto 2

WRITE 0, "1" 'if it wasnt 1 or 2 then it reaches here
goto startup

1:
2:

This way if it doesnt have a needed value, it writes it then restarts. The second time it runs it will have one of the right values.

[GatorGuy]

Quick EEPROM question while I'm at it. How reliable is the EEPROM memory? I want that value to stay there once the user selects it no matter how many shutdowns/powerups there are.

[Jerson]

A typical way that I use in my codings

At power on
if EEPROM_Magic <> $1234 then
' store initial defaults to EEPROM (as many as you need)
EEPROM_Magic = $1234 ' indicate I have valid readings here
' and save all these values to the eeprom
endif

' Now load the EEPROM values and continue with program

EEPROM_Magic is a word sized variable that is saved in EEPROM and contains a magic number that you choose(1234 Hex here)

Regards

[mackrackit]

Quick EEPROM question while I'm at it. How reliable is the EEPROM memory? I want that value to stay there once the user selects it no matter how many shutdowns/powerups there are.

They have something like 1,000,000 erase/write cycles.
Just make sure a write is not happening during power down.

And no " " " " " " " " " "

[Luckyborg]

I usually add this near the top of my code before any variable declarations

data @0, 0(256)             'set all EEPROM data to 0 on initial programming

Just be mindful of how much EEPROM your chip has, and you might want to write 255 instead of 0. You might only use 10 locations and that would look like

data @0, 255(10)             'set 10 EEPROM data to 255 on initial programming

Then early in the loop read and check for the default value

David

[Acetronics2]

Thanks for the ideas. I found an easy way now:

This isnt the code but gives the idea.

READ 0, blah
startup:
if blah = "1" then goto 1
if blah = "2" then goto 2

WRITE 0, "1" 'if it wasnt 1 or 2 then it reaches here
goto startup

1:
2:

This way if it doesnt have a needed value, it writes it then restarts. The second time it runs it will have one of the right values.

NO QUOTES AROUND VALUES !!!! ...
Grrrrr ...