Problem driving lcd from PIckit2 and 16F887

Closed Thread
Results 1 to 6 of 6

Hybrid View

  1. - 31st January 2010, 18:44 #1
    mackrackit's Avatar
    mackrackit
    mackrackit is offline SuperMod
    Join Date
    Nov 2003
    Location
    Wellton, U.S.A.
    Posts
    5,924

    Did you find this post helpful? Yes | No

    Default

    Are you using the 44 pin demo board?
    Dave
    Always wear safety glasses while programming.
  2. - 31st January 2010, 19:06 #2
    Davidmarks's Avatar
    Davidmarks
    Davidmarks is offline Junior Member
    Join Date
    Dec 2009
    Posts
    21

    Did you find this post helpful? Yes | No

    Default

    Yes I am ! ...and I just chickened out .. Connected the LCD to the default pins on Ports A and B and it now works. I just have now to modify the programs that use those ports unless I can figure out why it doesnt like ports D and E . Many thanks for your input
  3. - 31st January 2010, 19:28 #3
    mackrackit's Avatar
    mackrackit
    mackrackit is offline SuperMod
    Join Date
    Nov 2003
    Location
    Wellton, U.S.A.
    Posts
    5,924

    Did you find this post helpful? Yes | No

    Default

    Port D on that board goes to the LEDs unless the jumper is removed.
    Dave
    Always wear safety glasses while programming.
« Previous Thread | Next Thread »

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules