Hi all

After reading the link provided by NavMicroSystems I remember what happened when I used the ICD for the first time and I must say it originated a "melting" problem.

I just programmed a small program in a 16F628 and didn't take care about TRIS, because has I though then the ICD isintelligent enough to take care of that.

The ICD fail to start the first time due to wrong schematic provided by MCSplus helpfile, after correction of circuit at my second attempt and while I was at the PC keyboard trying to find what is wrong, suddenly it started smelling that something is not OK, when I turn back I found that the heat at the PIC pins has melted the plastic of my breadboard and "believe it or not" I could not remove the PIC from the breadboard, result: PIC=1 - breadboard=0.

In the General forum under "Which PBP Compiler are you using?" I appreciated the help from mister_e, here I thanks the guidance of NavMicroSystems with that link.

Credit should be given to those who know how to enlarge our small ideas.