Setting PortB.7 as output on 16F627/8/48

[Acetronics2]

I do hope your program has some more lines ...

Would you dare post them all ???

Alain

[Bruce]

I'm committed to a PCB that locks me into this pin

RB7 = PGD. Does your board have a PIC programmer connected, built-in, etc..?

[tekart]

Forgive my dyslexic brain - my issue is with PORTB.0

Well, all I need to test the output on PortB.7 is:

LED var PortA.0
Test:
HIGH LED
pause 500
low LED
pause 500
goto test

... and it ain't blinken.

[tekart]

Geez,
Forgive my confused last post. I was swapping things again. It's tough looking at the world through an upside down brain.

SO I got in there with my test probes and I had also mis-read my PCB traces. It's actually PortB.1. Really! I checked 3 times this time.

So is there some kind of register thing that I need to configure that as an output? It is the RX pin for hardware serial... is that a clue?

Sorry for the confusion.

[Archangel]

Geez,
Forgive my confused last post. I was swapping things again. It's tough looking at the world through an upside down brain.

SO I got in there with my test probes and I had also mis-read my PCB traces. It's actually PortB.1. Really! I checked 3 times this time.

So is there some kind of register thing that I need to configure that as an output? It is the RX pin for hardware serial... is that a clue?

Sorry for the confusion.

Cold up there in MAINE, Brrrrrrrrrrrrr
Upside down brain . . . Here in KaliForeignYa people have added dimensions to that, cause 80% of the folks here (at least those who drive) are looking out of their . . . Backsides. You're doing alright ! Use the portB.1 = 1, or PortB.1 = 0 and I am pretty sure it will work.

[tekart]

Thanks for the ideas, I swapped out the chip and it works, musta blown the output drivers when poking around with test probes. My blinky is working, I'm a happy camper!

Yeah, I'm a California ex pat. Today it's 32F and snowing, headed for 0F tonight. Mainah's have an expression: "If you don't like the weathah, wait 20 minutes".



Guy

[Archangel]

I do hope your program has some more lines ...

Would you dare post them all ???

Alain

No, because then YOU TOO would then know the secret of Matter / AntiMatter conversion, Time travel and Matter Teleportation . . . ;D . . . I will say sometimes HIGH / LOW does not work , and I do not know why. ALSO set your ports before your tris

[Bruce]

Assuming RB1 really, really, really, swear to "insert whomever you worship here" IS
the pin in question, then it can't ever be used for driving your LED if you have the hardware
USART enabled....