Simple RF remote control code

[Demon]

Are you using PM assembler?

If yes, make sure to point to MPASM assembler in the Microcode assembler settings.

It was most likely in the Microcode Studio download or get it here:

http://www.microchip.com/stellent/id...&part=SW007002

Robert

[Protech]

Thanks Robert! I did download it as I'm looking for solutions in Assembly, C and Basic both Microchip Pic and Atmel AVR.

I haven't programmed in PICbasic for some years. But now I capture the familiarity.

Again thank you very much.

Are you using PM assembler?

If yes, make sure to point to MPASM assembler in the Microcode assembler settings.

It was most likely in the Microcode Studio download or get it here:

http://www.microchip.com/stellent/id...&part=SW007002

Robert