Sounds like a good idea.
Use a different chip. That one may not work anymore.
<br>
DT
I tested on a separate circuit with a 3.0Voltage supply using PIC16LF877A and this Ram chip. There was some results come out, but not correct....
For example I wrote 100 into the first 100 location and the result come out to be 66 most of the time but some are 65. If I worte 0~100 accordingly in from address 0~100. The reads are some data from 0~66, it is also increasing accordingly, along with address shifting higher...it is weired..
I was wondering whether there is some error with my codes for these setups....
Hi Hankshone,
I'm experiencing the same exact problem like yours: always reading 255
I'm using a 23LVC1025, 5 volt SRAM memory chip with 5 volt micro. But still the same problem like yours.
Did you found what the problem was?
Best regards,
Mike.
Bookmarks