Problem runing my code

[Acetronics2]

Hi,

BUT ...

I think you could " re write " your project ... showing clearly what you want to do !!!

refresing your full display @ 200 Hz is not compulsory . 50/60 Hz is a classical value ... that leaves some time in between to do little other tasks ... while a digit is lit ...

You should Google around For the numerous ( ! ) alarm clock projects on the web ...

Difficult to help you not knowing what you want to do ....

Alain

[aratti]

i think none understands my quetion.i want to run like this code ..
i want both programes to run apart from each other its just example so i can write my programe like this plz help

You can obtain the two leds flashing at a different interval with a couple of variable:

Dled     Var Byte
Dled1   var Word

main:   '  led will blink @ 0,1 sec; led1 will be on for 2 secs off for 0,2 sesc
Pause 1

Dled = Dled + 1
Dled1 = Dled1 + 1

If Dled =>100 then
Toggle led
Dled = 0
endif

If Dled1 = 1 then high led1
If Dled1 = 2000 low led1
If Dled1 =>2200 then Dled1 = 0


goto main

Al.