Gusse

Thanks a million :-)
Already have the manual .. just wasn't sure and don't want to mess up and later have to trouble-shoot for ages.

Definitely what I am looking for though ...thank you!

Just a quick question regarding the 8MHZ oscialltor...(this is probably a silly questionbut...)
If I am going to be transmitting suing something like serout or debug from one PIC to another , first by wire(directly connected) and then by using wireless modules, would both PICS have to have the same internal oscillator setting ?
I have been sifting through many a thread on here and notice most people make the mistake of adding wireless TX and RX before they have tested using PIC to PIC communications.
I have been reading different code snippets and threads and noticed the various different oscillator settings as per each persons code and PIC.
then we come to the baud rate and so forth.
From what I have PICked up timing starts becomeing an issue at higher baud rates and whether you are going to using things alike HSER as opposed to debug or serin/out and serin/out 2.

Any thoughts ?

Kind regards

Dennis