PIC Interrupt and PORTA input

[Jerade]

My first post was supposed to have this link
http://www.picbasic.co.uk/forum/showthread.php?t=561
I must be getting old....

Can you post your code? It will help us to solve the problem.

Hi, Thanks for help, i ald solve the problem...
but got some problem with my project, later i will post my problem here hope somebody can help me, here is all professional and i am just a newbie..
hope u guys can lend me a hand....i will be appreciate very much, Thanks =)

[Acetronics2]

Hi, Jerade

You can get an interrupt from PORTA ...

see your Databook, Comparator section, ...

12.6 Comparator Interrupts
The comparator interrupt flag is set whenever there is
a change in the output value of either comparator.
Software will need to maintain information about the
status of the output bits, as read from CMCON<7:6>, to
determine the actual change that occurred. The CMIF
bit (PIR registers) is the Comparator Interrupt Flag. The
CMIF bit must be reset by clearing it (‘0’). Since it is
also possible to write a ‘1’ to this register, a simulated
interrupt may be initiated.
The CMIE bit (PIE registers) and the PEIE bit (INTCON
register) must be set to enable the interrupt. In addition,
the GIE bit must also be set. If any of these bits are
clear, the interrupt is not enabled, though the CMIF bit
will still be set if an interrupt condition occurs.

...

isn't it not marvellous ???

Alain