I have AXICOM P2 20941 DPDT relay switches. They are 12 pin dual in line configuration. The distance between the two rows of pins is .2 inches not enough (.3 inches) to bridge the channel in the solderless board. I need the DIP socket to make the necessary adjustment in width.

I hope to use the solderless boards at least to get started. They are sooo much easier.

A problems is that the hobby level RC components use three wire Z connectors; the radio receiver, female; the Electronic Speed Control, male; the Servo, male. I need to attach these to my circuit board. It is these lines that are switched by the DPTP relay switch.

Ken