PBP projects for R/C models

[ScaleRobotics]

I have four USB ports on the back and two on the front of my PC. How do I know into which physical port to plug the cable?

How does HyperTerminal know?

Ken

I have had equipment not get recognized when it was plugged into the front, so I would try the back.

Then, is any new hardware getting recognized when you plug it in? This is kind of a must have.

What step are we on. New device, or old device?

The only way that hyperterminal will know is if you tell it what com port it is. And the only way You will know, is if you look in Device Manager, and see a new serial port pop up when you plug the UBW32 in. And, the only way this will happen, is if the UBW32 gets recognized as new hardware. Which will only happen if we have the right firmware loaded .... etc... etc...

But I think we are getting closer.