Quote Originally Posted by Kenjones1935 View Post
Low and behold....
Ain't life grande.
Hey Ken,

Sorry I couldn't answer earlier. Are you all sorted out, or are there still questions? I think you may have answered yourself on all the above. But just in case:

Since I pointed you to a hex file, you will not need anything except your PicKit2 to load it into your UBW32. Sounds like you found the J5. Really I don't know where it is either, I just saw it clear as day on the schematic. You would think it might be labeled. I have played a bit with the CUI32, but not the UBW32. The CUI32 is very clearly marked for each pin. Sounds like that may not be the case with the UBW32.

Too bad it is not silk screened. That would have been helpful. I assume you are looking at this. Which could be a lot clearer. http://www.sparkfun.com/datasheets/D...MX460_v262.pdf

Are you able to upload the .hex firmware into the device with the Pickit2?