PBP projects for R/C models

[Kenjones1935]

CPUStick Basic sounds good. Let me guess at what I must do to get it.

1. Establish the connection between my PICkit2 Programmer and my new PIC32 Whacker.
2. Download from http://www.cpustick.com/downloads.htm one of the StickOS HEX images. Which image is the correct one for my PIC32?
3. Load this .hex image into my Whacker board FLASH using the PICkitr2 programmer.

My observation (from a READ command) is that the 512K of FLASH is blank. This surprised me because I thought the PIC32 Whacker came with embedded software.

Am I guessing correctly?

Ken

[ScaleRobotics]

CPUStick Basic sounds good. Let me guess at what I must do to get it.

1. Establish the connection between my PICkit2 Programmer and my new PIC32 Whacker.
2. Download from http://www.cpustick.com/downloads.htm one of the StickOS HEX images. Which image is the correct one for my PIC32?
3. Load this .hex image into my Whacker board FLASH using the PICkitr2 programmer.

My observation (from a READ command) is that the 512K of FLASH is blank. This surprised me because I thought the PIC32 Whacker came with embedded software.

Am I guessing correctly?

Ken

You got it 100% I thought it came pre-loaded with something too. But you need to write over it anyways. Use the firmware .hex I pointed to in this post: http://www.picbasic.co.uk/forum/show...4881#post94881

Walter

[Kenjones1935]

My browser insists on displaying your 'download' .hex file as if it were .txt.

I captured the SOURCE file and wrote it as a .hex file.

I have not looked at an actual .hex file in ages. Did I do the right thing?
Ken