PBP projects for R/C models

[mackrackit]

When bumping up to 8MHz try

pulsout trigfront,1

That should give you 5uS trigger. I was doing 4.

For external OSC I like ceramic resonators, good and bad to everything but with these you do not have to mess with capacitors, that is why I like them.
http://www.allelectronics.com/make-a...ATORS/-/1.html
The two outside pins will go to RA6 and RA7, the center to the zero rail (ground).
The problem with the 44 pin demo board is Micro Chip did not "ground" the via between RA6 and RA7, so you will have to run a jumper if you go this route.