PBP projects for R/C models

[ScaleRobotics]

The BIT Whacker schematic shows the connections from the 4 pin USB port [UBUS and USBID] to be different than the connections from 5 pins into J6 [PGB,PGC and RB2].

I think you are sticking your Pickit in the wrong port.

I know they are not spelled out as nice as the schematic, but, your pickit goes on J5 (same one I mentioned earlier). Later, after programming, you can try to plug in the usb host cable. The other 5 pin spots on the board are for USB.



Here is where it goes. Should be a lot happier now...: