Problem is that the Tx only gets power while the button is pressed once button is released, power is also removed from the pic. Is there any way I can achieve my goal using an capacitor or somthing at the output in the hardware as I dont seem to figure out an solution with software (Unless someone comes up with somthing I can try on my exsisting setup). I already tried using an 470uF at the output pin + replacing 1K wih an diode. I am having problem with timings now BUT flickering seems to have been absorbed by the capacitor. If possible any sugesstion about the cap values I can try to have instant responses by the receiver PIC?
Last edited by financecatalyst; - 24th October 2009 at 17:23.
___________________
WHY things get boring when they work just fine?
Bookmarks