Hi, I found a site that has a project that will help me setup mine. The project uses a potentiometer to vary the voltage to be read and display. It uses one port only ( portA.4) but for the test it’s good enough. I followed all the instructions and did the setup exactly as the program said. I copied the program and compiled it. The program describes that the displayed digital value will be from 0 to 1023. It worked as plan but the number displayed is a single digit not four as expected. This is the whole project site: C:\Documents and Settings\Dad\Desktop\mr k\adc2.pbp ,Please help me find what I am doing wrong. Thanks.