Thanx for that,

That's just another plus to choose the "Connect One" then ;-)

There were some issues with Mouser being restricted to Export Connect One devices to Australia, although now i'm informed by Connect One the restriction will be lifted in a few days, and i should contact Mouser again to place orders.....

In my initial research i thought ALL ethernet modules were simply controlled with serial/spi commands, but after digging deeper i started finding that wasn't always the case, and some modules required lower level information etc.....something i DIDN'T want to embark on......

Thanx again.



Quote Originally Posted by dhouston View Post
With the ConnectOne modules (and the ENC28J60) you do not need the Microchip stack. You connect using either serial (RS232 TTL) or SPI.

Read the ConnectOne AT+i Programmer's Manual. Basically, you communicate with the nano LanReach using AT commands in the same manner as with a modem using the serial interface. It's very simple.

With the ENC28J60, you are working at a lower level and it is far more complicated.

Stick with ConnectOne.