Hi Dave, thanks for the replies and I really do appreciate it. Ahm...I'm a little confuse, I hope you dont mind if I'm very slow to pick it all up. But may I explaine my hardware setup to understand what I'm missing.
PC side: [Port - COM7] [Baud rate - 9600] [Byte size - 8] [Stop bit - 1]
Sends character data 'A' over COM7 as given(device discovery).
EBC-04 side: [Operates on 3.3v] [Baud rate - 9600] [Byte size - 8] [Stop bit - 1]
PIC side: [Baud rate - 2400] PortC.7-->Rx
Okay, I understand that I need to change 2400 to 9600 from PIC baud rate to communicate with EGBC. There are two option as I see, either I change the baud rate of the EGBC using AT commands by connecting to the pc with LVTTL TO RS-232 CONVERTER or change PIC's baudrate. But I dont have TTL to RS232 converter right now. So changing the Pic's baud rate is my option. I'm using 4MHZ crystal..how do I change it to 9600?
Thanks,
mbox
Bookmarks