ok ive made my code, probably got some errors in, however thats not the problem. ive been thinking about this whole trouble with if the voltage is idling on a point lower than my low voltage detection level but not low enough that it causes a reset... problem is.. if it gets too that point my program starts looping because the interupt keeps getting set off by the low voltage.

i was thinking since when the wind turbine actually gets slow enough that the voltage is about 2-3 volts, its not actually giving out any power (if it does then its completely negligible). so when i get to a low point can i just turn off the pic? and get it too restart when the power gets higher?