sony
Ok sounds like you changed the program some to test different hex commands?
You need the two different pins portb1 and and portb2 one looks for interframe gaps and startbits the other sends commands did you use the pulldown resistor on Portb1 and did you use two resistors one for each pin to the lanc line and of course ground I did it this way for testing so I could put the scope on either lead and check for pulse voltage. I found sometimes I needed the pulldown resistor to get clean pulses that would go 0 to 3vdc not 1.3 to 3vdc. Thanks for testing this, sometimes no matter how much you work on something, when someone tries it, it may or may not work and this is what I wanted to see.
Now try the program as written turn the camera on first then turn the pic on the camera will shutoff wait 10 seconds turn on wait 10 seconds record wait 20 seconds stop record wait 10 seconds and turn off and go through all this again Im using a DCR-HC20 sony camera. I listed the commands that worked with my camera. Let me know what happens.
Larry
Bookmarks