Quote Originally Posted by HenrikOlsson View Post
Hi,
Again, you don't have to use the index channel, it'll work fine without it. If you set up the QEI module to reset on index (as in my example) and the encoder doesn't have an index channel the counter will simply roll over from $FFFF to $0000 or from $0000 to $FFFF depending on direction. Carefully read the section of the datasheet, play with it a bit and read the datasheet again, you'll figure it out ;-)

/Henrik.
Yes I was read that part a couple of time and again and again...
How I see that full 18F4431 is extra MCU and most of you must do is to set
tons of nibbles on config registers but!
If you do that right you will have pleasure to use many finished hardware periferials without to much programing...inside 18F4431 is so many good things...

Regards Robert